2
Insert the appliance plug into the appliance (Fig. 4).
3
Put the adapter in the wall socket.
the charging light
flashes green to indicate that the appliance is
charging (Fig. 5).
4
After charging, remove the adapter from the wall socket and pull the
appliance plug out of the appliance.
Optimising the lifetime of the rechargeable battery
When you have charged the appliance
for the first time, we advise you to
use it until the battery is completely empty.
Do not recharge the appliance in between the trimming sessions.
Continue to use the appliance until the motor almost stops running during
a session. Then recharge the battery. Follow this procedure at least twice a
year.
Trimming
When you trim for the first time, be careful. Do not move the trimmer
too fast. Make smooth and gentle movements.
Trimming with beard trimming comb
1
Turn the Precision Zoom Lock
`
adjustment ring to the
desired setting. (Fig. 6)
You can choose any setting between 0.5 and 10 mm. The selected setting is
indicated by the arrow above the Precsion Zoom Lock
`
.
Note: When you trim for the first time, start at the highest setting (10) to
familiarise yourself with the appliance.
2
Switch on the appliance (Fig. 3).
3
To trim most effectively, move the trimmer against the hair growth
direction. Make sure the surface of the comb always stays in full
contact with the skin (Fig. 7).
,
EnGlIsh
Cleaning
The appliance is fully washable.
Never use compressed air, scouring pads, abrasive cleaning agents or
aggressive liquids such as petrol or acetone to clean the appliance.
1
Make sure the appliance is switched off and disconnected from the
mains.
2
Remove the beard trimming comb (Fig. 8).
Note: Never pull at the flexible top of the beard trimming comb. Always pull at
the bottom part.
3
Open the cutting unit (Fig. 9).
4
Clean the inside and outside of the appliance under a running tap or
use the cleaning brush (Fig. 10).
5
Push the cutting unit back onto the appliance to close it
(‘click’) (Fig. 11).
Note: The appliance does not need any lubrication.
Replacement
Only replace a worn or damaged cutting unit with an original Philips cutting
unit, available from authorised Philips service centres.
1
Open the cutting unit (Fig. 9).
2
Pull the old cutting unit upwards to remove it (Fig. 12).
3
Insert the two lugs of the new cutting unit into the guiding
slots (Fig. 13).
4
Push the cutting unit back onto the appliance (‘click’) (Fig. 11).
Environment
Do not throw away the appliance with the normal household waste
at the end of its life, but hand it in at an official collection point for
recycling. By doing this, you help to preserve the environment (Fig. 14).
The built-in rechargeable battery contains substances that may pollute
the environment. Always remove the battery before you discard and
-
-
EnGlIsh
QT4022改訂_01-22_1221.indd 16
12.12.21 4:28:57 PM
