12
EN
Prepare the remote control
Caution
•
Risk of explosion! Keep batteries away from heat,
sunshine or fire. Never discard batteries in fire.
For first-time use:
•
Remove the protective tab to activate the
remote control battery.
To replace the remote control battery:
1
Open the battery compartment.
2
Insert one CR2032 battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Note
•
Before you press any function button on the remote
control, first select the correct source with the remote
control instead of the main unit.
•
If you are not going to use the remote control for a
long time, remove the battery.
•
Point the remote control directly at the IR sensor on
the front of the main speaker for better reception.
Turn on
•
Press .
»
The SoundSphere DesignLine speakers
switch to the last selected source.
»
The source indicator lights up in the
corresponding color.
Switch to sleep mode
•
Press again to switch the SoundSphere
DesignLine speakers to sleep mode.
»
While the source indicator turns off,
the power indicator lights up red.
Tip
•
To switch the SoundSphere DesignLine speakers on
from sleep mode again, you can also press the power
key on the remote control of your TV connected
through HDMI ARC.
•
In sleep mode, when you turn on the TV connected
through HDMI (ARC), the SoundSphere DesignLine
speakers wake up automatically.
To switch to standby mode:
•
Press and hold for more than three
seconds.
»
The power indicator turns off.
To activate the auto power down feature:
•
Press down the
APD
switch on the back of
the main speaker ( : on; : off).
»
After staying idle for 30 minutes, the
SoundSphere DesignLine speakers
enter standby mode automatically.
Tip
•
To wake up from standby mode, you can press
on the main speaker or the remote control of the
SoundSphere DesignLine speakers.
