Philips Pronto RFX9400, Руководство для начинающих

Страница: 8 / 40

5
RFX9400 Starter’s Guide
To configure the Network Extender:
1
Connect the Extender to the PC with the
configuration cable (this is the crossed
Ethernet cable enclosed).
2
Set the switches correctly:
Note • If there is already an Extender with ID 0, set the Extender ID switch to an ID that is not
used yet.
• Make sure the same Extender ID is used on the Extender and the Pronto Control Panel.
3
Plug in the Extender’s power adapter .
The Extender will start up. After startup, the Power and Ethernet LEDs are green and the Busy
LED is red/green blinking.
4
Open the browser .
5
Type the IP address of the Extender (printed on the bottom of the Extender) in the
address bar of the browser.
The Configuration Tool opens in the browser.
6
Follow the onscreen instructions and make sure you have the following information at
hand:
• If the Extender will be connected wirelessly to the Pronto Network: the SSID and
encryption settings .
• If the Extender will be operating with a fixed IP address: the IP address , netmask and
default gateway .
Tip To ensure optimal performance, use a dedicated network for all Pronto communication.
This makes the Pronto Network independent from other network traffic and changes in
network settings.
7
Disconnect the Extender from the PC.
8
Connect the Extender to the Pronto Network:
• For a wired connection, connect the Extender to the router by means of a straight Ethernet
cable.
• For a wireless connection, you do not need to connect any more cables.
9
Set the switches correctly:
The Extender will restart. After startup,
• In a
wired network connection, the Power and Ethernet LEDs are green and the Busy LED
blinks green when it’s processing a code or a macro from the Control Panel.
• In a wireless network connection, the Power and WiFi LEDs are green and the Busy LED
blinks green when it’s processing a code or a macro from the Control Panel.
Extender Configuration
cable
Stand-alone/Network Network
Configuration switch 2
Extender ID 0
Stand-alone/Network Network
Configuration switch 1
Extender ID 0
RFX9400_SG_ESF_v06.qxd 04-07-2006 08:12 Pagina 8