Philips Pronto RFX9400, Руководство для начинающих

Страница: 12 / 40

9
RFX9400 Starter’s Guide
The Busy LED blinks green when the Control Panel is not in use
This does not mean that something is wrong with the Extender. It merely indicates that the Extender
is being operated by a different Control Panel. When the Busy LED stops blinking, you can use the
Extender again.
Resetting the Extender
This is only necessary when the Extender displays unusual behavior.
To perform a reset, unplug the Extender from the electrical socket. Wait a few seconds, and plug it
in again.
Firmware Update
When an update of the Extender firmware is available, this will be announced on the Philips Pronto
website:
www.pronto.philips.com .
Note You can always see the current version of the firmware in the Configuration Tool.
1
Download the new version of the firmware on the PC.
2
Unplug the Extender. The Extender can be updated in the following ways.
Updating the Extender with the configuration cable
1
Connect the Extender to the PC with the configuration cable.
2
Set the switches correctly.
3
Open the browser .
4
Type the IP address of the Extender (printed on the bottom of the Extender) in the
address bar of the browser.
The Configuration Tool opens in the browser.
5
Select Firmware Update in the left navigation pane.
The Firmware Update page opens.
6
Follow the onscreen instructions.
Updating the Extender through a router
If the Extender is already installed and connected to AV-equipment, it may be more convenient to
update it through a router.
1
Connect the Extender to the router, and the router to the PC.
2
Set the switches correctly.
Stand-alone/Network Network
Configuration switch 2
Extender ID 0
Stand-alone/Network Network
Configuration switch 3
Extender ID 0
RFX9400_SG_ESF_v06.qxd 04-07-2006 08:12 Pagina 12