Philips HTS3538 Series, Быстрый старт

Страница: 20 / 27

18 EN
Main unit
•
Power supply:
•
Europe/China/Russia/India: 220-240V~,
50 Hz
•
Latin America/Asia Pacific: 110-240V~,
50-60 Hz
•
Power consumption: 110 W
•
Standby power consumption: ≤ 0.9 W
•
Dimensions (WxHxD): 360 x 58 x 325 mm
•
Weight: 2.52 kg
Subwoofer
•
Output power: 100 W RMS (30% THD)
•
Impedance: 4 ohm
•
Speaker drivers: 133 mm (5.25") woofer
•
Dimensions (WxHxD): 160 x 267.5 x 265 mm
•
Weight: 2.55 kg
Speakers
Center speaker:
•
Output power: 100 W RMS (30% THD)
•
Speaker impedance: 4 ohm
•
Speaker drivers: 1 x 63.5 mm (2.5") woofer
•
Dimensions (WxHxD): 160 x 85 x 95 mm
•
Weight: 0.37 kg
Front/Rear speaker:
•
Output power: 4 x 100 W RMS (30% THD)
•
Speaker impedance: 4 ohm
•
Speaker drivers: 1 x 76.2 mm (3") twin driver
•
Dimensions (WxHxD):
•
Speakers: 85 x 160 x 95mm
•
Tall speakers: 240 x 1007 x 240 mm
•
Weight:
•
Speakers: 0.35 kg/each
•
Tall speakers: 1.57 kg/each
Remote control batteries
•
2 x AAA-R03-1.5 V
Laser
•
Type: Semiconductor laser GaAIAs (CD)
•
Wave length: 645 - 665 nm (DVD), 770 - 800
nm (CD)
•
Output power: 6 mW (DVD), 7 mW (VCD/CD)
•
Beam divergence: 60 degrees.
8 Troubleshooting
Warning
•
Risk of electric shock. Never remove the casing
of the product.
To keep the warranty valid, never try to repair the
product yourself.
If you have problems using this product, check the
following points before you request service. If you
still have a problem, get support at www.philips.
com/support.
Main unit
The buttons on the home theater do not work.
•
Disconnect the home theater from the
power supply for a few minutes, then
reconnect.
Picture
No picture.
•
Make sure that the TV is switched to the
correct source for the home theater.
•
If this happens when you change the
TV system, press to open the disc
compartment, and then 439 on the remote
control to restore the default TV system.
No picture on a TV connected through HDMI.
•
Make sure that the HDMI cable is not faulty. If
it is faulty, replace it with a new cable.
•
If this happens when you change the HDMI
video resolution, press to open the disc
compartment, and then
304
on the remote
control to restore the default setting.
•
Wait for 10 seconds for auto recovery, or
change the HDMI video setting.
Disc does not play high-definition video.
•
Make sure that the disc contains high-
definition video.
•
Make sure that the TV supports high-
definition video.
•
Use an HDMI cable to connect to the TV.