background image

HD7853/60 /61 /62

4-11

Descaling

Descaling is an important element in Senseo maintenance.
It should be done at least once every 3 months, up to 6 times 
a Year!  This will prolong the life of your appliance and will 
guarantee optimal brewing results for a long time.

Use the correct descaling agent

.  Only citric acid-based 

descalers are suitable for descaling the SENSEO

®

 machine. 

This type of descaler descales the appliance without damaging 
it.  For the correct amount, see under ‘Descaling procedure’ 
below.
Each descaling mixture can be used only once.  After use, the 
descaling mixture is no longer active.  We advise you to use 
the special SENSEO

®

 Descaler (HD7006).

Read the instructions on the package of the descaling agent. 
Never use a descaling agent based on mineral acids such as 
sulphuric acid, hydrochloric acid, sulphamic acid and acetic 
acid (e.g. vinegar).  These descaling agents may damage your 
SENSEO

®

 coffee machine.

Follow the steps in the section headed “Descale the appliance” 
see DFU (Direction for Use manual).

Volume adjustment

The PCB circuit board makes it possible to adjust the volume 
output by means of pushing the one-cup and two-cup user 
controls.

How to adjust the volume output:

1.  Be sure the boiler is fi lled properly, other wise perform fi ll 

procedure see DFU for instructions.

2.  Switch appliance on and wait until the unit is ready to brew.
3.  Choose the setting of which you want to adjust the volume 
4.  Be sure a 

pod holder

 is placed, but 

without

 a Coffee 

POD.  (Only adjusting with plain water)

5.  Place a cup on the drip tray cover.

Press the 1-cup button once to measure the black coffee 
volume, press the 1-cup button twice to measure the 
coffee volume in a cappuccino.

6.  When the appliance has fi nished it is stabilized to perform 

the volume adjustment. 

7.  Empty the cup, podholder and push again for one cup 

setting, measure the volume output with a graduated 
beaker.  In the table you can fi nd the requirements for 
the minimum / maximum volume output cc/mL values 
depending from the country version:

One-cup setting, Including Pod holder, water spec.

(Without Coffee pod)

Min. water cc/mL

Max. water cc/mL

General

125

141

France

104

120

Spain

65

81

Cappuccino

65

81

Start -

Unplugged appliance

Adjust what?

Black coffee volume

Coffee volume in

cappuccino recipe 

Do NOT

insert Milk

Container

Insert Milk

Container

Press 1-cup & 2-

cup button

simultaneously

Press 1-cup & 2-

cup button

simultaneously

Plug the

appliance

into the

mains

If above steps were successful,

1-cup, On/Off & 2-cup button will be lit

Press what?

Decrease

pump time with

0,5 sec. 3,5mL/cc

Increase

pump time with

0,5 sec. 3,5mL/cc

Store settings

1-cup button

2-cup button

On/Off

button

8.  Turn appliance on again and brew one cup, measure the 

volume.  In case the volume is not within specifi cation 
repeat step 7.

9. End.

REPAIR INSTRUCTION

Содержание HD7853/60












Отзывы: