Philips HB871, Руководство пользователя

Страница: 16 / 110

below. Read the instructions below to check whether you can solve the
problem yourself before contacting your dealer or the Philips Service
Centre.
ENGLISH
16
Possible cause
Plug has not been (properly) inserted into the wall socket.
There is a power failure. Check by means of another appliance.
The lamps are still too hot to go on. Let them cool down for 3 minutes first.
The appliance was not sufficiently cooled and the overheating protection switched
appliance off automatically. Remove the cause of overheating (e.g. remove a towel
that is blocking one or more vents). Wait for 10 minutes and switch the appliance
back on.
The two side lamp units and the centre lamp unit have not been put in the right
position (see 'Preparing for use').
Check the fuse of the circuit to which the solarium is connected.The correct fuse
type is 16A standard fuse or a slow-blow automatic fuse.The fuse may also blow
because you have connected (too many) different appliances to the same circuit.
You are using an extension cord that is too long, that is wound up and/or does not
have the correct rating (16A). Consult your dealer. Our general advice is not to use
an extension cord.
You are not following the tanning schedule suitable for your skin type.
The distance between the lamps and the surface you lie on is greater than
prescribed.
When the lamps have been used for a long time, the UV emitted will decrease.
This effect only becomes noticeable after several years.You can overcome this
problem by selecting a longer tanning time or by having the lamps replaced.
You have not pushed the upper part of the appliance backward far enough. Make
sure you first push the upper part backward before pushing it down (see 'Storing').
The appliance fails to unlock automatically. In that case you first have to press
unlocking button (C), after which you can fold the appliance back into its transport
position in the manner indicated in the section 'Transport position'. If the appliance
fails to unlock several times, contact your dealer or a Philips Service Centre.
Problem
Appliance does not start
The fuse cuts off the power when you
switch on the solarium or during use.
Poor tanning capacity
The solarium cannot be placed back in the
transport position.