Directions for Use
EN 7
FHP PDP
3.
3.
Directions for Use
Not applicable.
4.
Mechanical Instructions
Index of this chapter:
4.1 Board Swap Instructions
Notes:
•
Figures below can deviate from the actual situation, due to
different set executions.
•
For more detailed instructions regarding the (dis)assembly
of the TV chassis that hold these PDPs, read the
corresponding TV Service Manual.
4.1
Board Swap Instructions
4.1.1
General
Before dismounting panels read notes below!
Caution when removing circuit board!
When removing the circuit board after the main power is turned
on/off, wait for at least one minute before starting to remove the
circuit board.
If the circuit board removal is started immediately after turning
off the main power, it can result in electric shock or damage to
the circuit due to residual electric charge.
Caution on handling the FPC connector!
To release the black lock lever of the connector, flip it up gently
in the middle with the nail of the thumb or forefinger, from the
side with the cable. Never pinch the lock lever with fingers or
tools.
Doing so might damage the lock lever.
Figure 4-1 Handling the FPC connector
4.1.2
X-SUS Circuit Board
Figure 4-2 X-SUS board removal (1)
Figure 4-3 X-SUS board removal (2)
Remove the circuit board by following the steps below. To
install the circuit board, reverse the removal procedure.
1.
Remove the fixing screws (M3 X 8).
2.
Release the lock of the FPC connector (CN21) and
disconnect the signal cable.
E_14580_025.eps
071005
(5)
(5)
(5)
(5)
(3)CN21
(4)CN26
(5)
(4)CN22
(2)CN24
(1)
(1)
(1)
Pull out
(6)
(6)
(1)
(3)CN23
(2)CN25
F_14582_006.eps
071005
Pull out
(6)
F_14582_007.eps
300905
