Dynalite Hardware
.......................................
Installation Guide
.......................................
Page 16
.......................................
14
th
November 2019
www.philips.com/dynalite
Controller Service Switch functions
The relevant Service Switch functions are:
•
3 pushes
= All Channels 100%. You should do this to normalize the connected driver settings.
(DALI Broadcast Channels will setup the connected drivers with Min/Max/PowerOn/SystemFail levels,
and 2 second Fade Time).
•
4 pushes
= A DALI enumerated controller will run a flash sequence for 5 minutes.
•
Push and hold for 5 seconds and release
= Device reset
Controller Service LED functions
The Service LED has four signaling modes:
•
Blinking slowly (0.5Hz)
= Normal operation.
•
Blinking normally (1Hz)
= Network activity detected or DMX reception.
•
Blinking fast (4Hz)
= Device communicating.
•
Permanently ON or OFF
= Fault.
D
Some devices support a bicolor service LED. The same blinking pattern is valid for both Red and Green
LEDs. Red is the standard color for all devices. Green shows reception of DyNet heartbeat from another
DyNet device, such as a Gateway.
