Philips BDP7100/12, Руководство по обслуживанию

Страница: 6 / 67

EN 6 3139 785 32970
2. Precautions
CAUTION : Before servicing units covered by this
service manual and its supplements, read and follow
the Safety Precautions section of this manual.Note : If
unforseen circumstances create conflict between the
following servicing precautions and any of the safety
precautions, always follow the safety precautions.
Remember: Safety First.
2-2-1 General Servicing Precautions
(1) a. Always unplug the instrument’s AC powercord
from the AC power source before (1) re-moving
or reinstalling any component, circuit board,
module or any other instrument assembly, (2)
disconnecting any instrument electrical plug or
other electrical connection, (3) connecting a test
substitute in parallel with an electrolytic ca pacitor
in the instrument.
b. Do not defeat any plug/socket B+ voltage
interlocks with which instruments covered by this
service manual might be equipped.
c. Do not apply AC power to this instrument and/or
any of its electrical assemblies unless all solid-
state device heat sinks are correctly installed.
d. Always connect a test instrument’s ground lead
to the instrument chassis ground before connecting
the test instrument positive lead. Alwaysremove
the test instrument ground lead last.
Note : Refer to the Safety Precautions section ground
lead last.
(2) The service precautions are indicated or printed
on the cabinet, chassis or components. When
servicing, follow the printed or indicated service
precautions and service materials.
(3) The components used in the unit have a specified
flame resistance and dielectric strength. When
replacing components, use components which
have the same ratings. Components identified
by shading, by ( ) or by ( ) in the circuit diagram
are important for safety or for the characteristics
of the unit. Always replace them with the exact
replacement components.
2-2 Servicing Precautions
(4) An insulation tube or tape is sometimes used
and some components are raised above the
printed wiring board for safety. The internal wiring
is sometimes clamped to prevent contact with
heating components. Install such elements as they
were.
(5) After servicing, always check that the removed
screws, components, and wiring have been
installed correctly and that the portion around the
serviced part has not been damaged and so on.
Further, check the insulation between the blades
of the attachment plug and accessible conductive
parts.
2-2-2 Insulation Checking Procedure
Disconnect the attachment plug from the AC outlet
and turn the power ON. Connect the insulation resist-
ance meter (500V) to the blades of the attachment
plug. The insulation resistance between each blade of
the attachment plug and accessible conductive parts
(see note) should be more than 1 Megohm.
Note : Accessible conductive parts include metal
panels,input terminals, earphone jacks, etc.