Battery-Monitor BLS
REV 1A – APR 2019 - Software Version 1A
page 3
Both the compliance with the operating instructions and the conditions and methods for installation,
operation, use and maintenance of the battery monitor BLS cannot be monitored by philippi
electrical systems gmbh. Therefore, we assume no responsibility or liability for any loss, damage or
expense resulting from improper installation or improper operation.
1.5 Quality assurance
During production and assembly, the devices undergo several checks and tests. Fabrication, checks
and tests are carried out according to established protocols. Each device has its own serial number.
Never remove the nameplate. The assembly and the test of all devices are carried out completely in
our facilities.
2. Safety instructions
• It must not be changed on the device, otherwise it will go out
CE mark
• The battery monitor may only be connected by qualified electricians.
• Disconnect the battery leads before connecting the battery monitor.
• Pay attention to the correct polarity of the batteries!
• The power supply to the monitor and shunt must be protected.
• This device is not intended for use by children.
The present installation and operating instructions are part of the component delivery. It must - well
important for subsequent maintenance - well kept and passed on to any subsequent owners of the
device.
3. Installation
3.1. Monitor
Install the monitor in a protected, dry and well-
visible place so that it can be read at any time. The
cut-out is 86 x 59 mm, the required minimum depth
is 40mm. On the back side there is a 4-pin terminal
for the power supply of the monitor and the
communication li ne to the shunt SHE.
On the back side, a software update can be
uploaded to the monitor via a micro SD card.
The power supply of the monitor can be interrupted at any time without losing battery status data,
as these are stored in the shunt SHE 300.
