Philio PHI PST02-1B, Быстрый старт

Страница: 6 / 9

06-10-2020 14 : 42
Pagina 6 van 9 http://manual.zwave.eu/backend/make.php?lang=en&sku=PHI_PST02-1B
Setting Description
1 Reserve.
2 1 means test mode, 0 means normal mode. Notice: This bit only effect by the DIP Switch setting to “cust
mode”, otherwise it decides by DIP Switch setting to Test or Normal Mode
4
Reserve.
8 Setting the temperature scale. 0: Fahrenheit, 1:Celsius
16 Disable the illumination report after event triggered. (1:Disable, 0:Enable)
32 Disable the temperature report after event triggered. (1:Disable, 0:Enable)
64 Reserve.
128 Disable the back key release into test mode. (1:Disable, 0:Enable)
Parameter 6: Mult-Sensor Function Switch
Multisensor function switch. Using bit to control.
Size: 1 Byte, Default Value: 4
Setting Description
1 Reserve.
2 Disable PIR integrate Illumination to turn ON the lighting nodes in the association group 2. (1:Disable, 0:
4 Reserve.
8 Reserve.
16 Reserve.
32 Reserve.
64 Reserve.
128 Reserve.
Parameter 7: Customer Function
Customer function switch, using bit control.
Size: 1 Byte, Default Value: 4
Setting Description
1 Reserve.
2 Enable sending motion OFF report. (0:Disable, 1:Enable)
4 Enable PIR super sensitivity mode. (0:Disable, 1:Enable)
8 Reserve.
16 Notification Type, 0: Using Notification Report. 1: Using Sensor Binary Report.
32 Disable Multi CC in auto report. (1:Disable, 0:Enable)
64 Disable to report battery state when the device triggered. (1:Disable, 0:Enable)
128 Reserve.
Parameter 8: PIR Re-Detect Interval Time
In the normal mode, after the PIR motion detected, setting the re-detect time. 8 seconds per tick, default tick is 3 (24 seconds).Setting the suitable value to
received the trigger signal too frequently. Also can save the battery energy.Notice: If this value bigger than the configuration setting NO. 9. There is a period
light turned off and the PIR not start detecting.
Size: 1 Byte, Default Value: 3
Setting Description
1 - 127 PIR Re-Detect Interval Time
Parameter 9: Turn Off Light Time
After turn on the lighting, setting the delay time to turn off the lighting when the PIR motion is not detected. 8 seconds per tick, default tick is 4 (32 seconds).
never send turn off light command.