06-10-2020 14
:
42
Pagina 1 van 9
http://manual.zwave.eu/backend/make.php?lang=en&sku=PHI_PST02-1B
Philio Tech
Z-Wave 3 in 1 Sensor (Motion,
Illumination, Temperature)
SKU: PHI_PST02-1B
Quickstart
This is a
secure Alarm Sensor
for
Europe
. To run this device please insert fresh
1 * CR123A
batteries. Please make sure the internal battery is fully ch
To add this device to your network execute the following action:
1. Have Z-Wave Controller entered inclusion mode.
2. Pressing tamper key three times within 1.5 seconds to enter the inclusion mode.
3. After add successful, the device will wake to receive the setting command from Z-Wave Controller about 20 seconds.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, import
distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use
equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sou
What is Z-Wave?
Z-Wave is the international wireless protocol for communication in the Smart Home. This device is suited for use in the region mentioned in the Quickstart se
Z-Wave ensures a reliable communication by reconfirming every message (
two-way communication
) and
every mains powered node can act as a repeater for other nodes (
meshed network
) in case the receiver is not
in direct wireless range of the transmitter.
This device and every other certified Z-Wave device can be
used together with any other certified Z-Wave
device regardless of brand and origin
as long as both are suited for the same frequency range.
If a device supports
secure communication
it will communicate with other devices secure as long as this
device provides the same or a higher level of security. Otherwise it will automatically turn into a lower level of
security to maintain backward compatibility.
For more information about Z-Wave technology, devices, white papers etc. please refer to www.z-wave.info.
Product Description
The Z-Wave Plus 3 in 1 sensor is designed with three detection sensors:
1. PIR/Motion
2. temperature
3. illumination
The detector can be used as a security device or home automation device. When the detector is cooperated with security appliances, the detector is
security device by detecting changes in infra-red radiation levels. If a person moves within or across the devices field of vision, a trigger radio signal will be
to cause full alarm condition in order to frighten intruders away. Once night falls, the percentage of ambient illumination is lower than preset value. If a pe
within or across the devices field of vision, a trigger radio signal will be transmitted so as to turn connected lightings for better illumination. Every time wh
the sensor will also send temperature and illumination value as well. Also the temperature will send out the value when temperature changes. Note: The
sensor does not work with Fibaro Homecenter 2 and Zipabox yet.
