2
Function
Description
Annotation
No node ID
The Z-Wave Controller does not
allocate a node ID to the Switch.
LED 2-second on,
2-second off
Add
1.Put your Z-Wave controller into
inclusion mode by following the
instructions provided by the
controller manufacturer.
“
”LED blink three times.
2. Press and hold “
” button first,
then press “
┿
┿
┿
┿
” button three times
within 2 seconds will enter inclusion
mode.
Remove
1.Put your Z-Wave controller into
exclusion mode by following the
instructions provided by the
controller manufacturer.
“
”LED blink three times.
2. Press and hold “
” button first,
then press “
┿
┿
┿
┿
” button three times
within 2 seconds will enter exclusion
mode.
3. Node ID has been excluded.
Reset
1. Press and hold “
” button first,
then press “
┿
┿
┿
┿
” button three times
within 2 seconds will enter inclusion
mode.
Use this procedure only in
the event that the primary
controller is lost or
otherwise inoperable.
2.Within 1 second, press “
┿
┿
┿
┿
” button
again and hold for 5 seconds.
3. IDs are excluded.
LED 2-second on, 2-second
off
Adding a node ID allocated by Z-Wave Controller means inclusion. Removing a node
ID allocated by Z-Wave Controller means exclusion.
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
LED Indication
To distinguish what mode the switch is in, view from the LED for identification.
State Type
LED Indication
Normal
Under normal operation, short pressing
“
”
button will turn On and
Off. When switch turns on, green LED lights up, whereas turns off,
red LED is lights up.
No node ID
Under normal operation, when the Switch has not been allocated a
node ID, the
“
”
LED flashes on and off alternately at 2-second
intervals.
Learning
When PAN24 enter include or exclude mode by pressing the
combination of
“
” button and “
┿
┿
┿
┿
” button
,
“
”
LED will flashes
three times 0.5 second intervals.
Overload
When overload state occurs, the switch is disabled of which
“
”
LED flashes on and off alternately at 0.2 second intervals. Overload
state can be cleared by disconnecting and reconnecting the Switch
to the wall outlet.
Overview