3
Adding to Z-Wave
TM
Network
In the front casing, there is an On/Off button with LED indicator which is used to toggle
switch on and off or carry out inclusion, exclusion, reset or association. When first
power is applied, its LED flashes on and off alternately and repeatedly at 0.5 second
intervals. It implies that it has not been assigned a node ID and start auto inclusion.
Auto Inclusion
The function of auto inclusion will be executed as long as the switch does not have
Node ID and just plug the switch into a wall outlet.
Note: Auto inclusion timeout is 2 minute during which the node information of explorer
frame will be emitted once several seconds. Unlike “inclusion” function as shown in
the table below, the execution of auto inclusion is free from pressing the On/Off button
on the Switch.
The table below lists an operation summary of basic Z-Wave functions. Please refer to
the instructions for your Z-Wave
TM
Certificated Primary Controller to access the Setup
function, and to Add/Remove/Reset/Associate devices
Function
Description
Annotation
No node ID
The Z-Wave Controller does not allocate
a node ID to the Switch.
2-second on, 2-second off
Add
(Inclusion)
1.
Put your Z-Wave controller into
inclusion mode by following the
instructions provided by the
controller manufacturer.
To support handling of
the device when already
installed the external switch
can be used for inclusion or
exclusion for 3 minutes
after power up.
2. Pressing On/Off button three times
within 2 seconds will enter inclusion
mode.
Remove
(Exclusion)
1. Put your Z-Wave controller into
exclusion mode by following the
instructions provided by the
controller manufacturer.
To support handling of
the device when already
installed the external switch
can be used for inclusion or
exclusion for 3 minutes
after power up.
2.
Pressing On/Off button three times
within 2 seconds will enter exclusion
mode.
Node ID has been excluded.
0.5s On, 0.5s Off (Enter
auto inclusion)
Reset
1.
Pressing On/Off button three times
within 2 seconds will enter inclusion
mode.
Use this procedure only in
the event that the primary
controller is lost or
otherwise inoperable.
2.
Within 1 second, press On/Off
button again for 5 seconds.
3.
IDs are excluded.
0.5s On, 0.5s Off (Enter
auto inclusion)
Association
1. The PAN03 is an always listening
Z-Wave device, so associations may
be added or removed by a controller
at any time.
Or If your controller requires to have
the PAN03 send a 'node information
frame' or NIF for associations, then
pressing the On/Off button three
times within 2 seconds will cause
the PAN03 to send its NIF.
2. There are only one group for the
switch
Adding a node ID allocated by Z-Wave Controller means inclusion. Removing a node
ID allocated by Z-Wave Controller means exclusion.
Failed or success in including/excluding the node ID can be viewed from the Z-Wave
Controller.
Sometimes people are not easy to execute exclusion or inclusion especially when
PAN03 already installed in a wall box. To solve this issue, PAN03 support a special
feature that can use S1 or S2 to execute “exclusion, inclusion, Reset or Association”
at the first 3 minutes when first time connect to main power
LED Indication
To distinguish what mode the switch is in, view from the LED for identification.
State Type
LED Indication
Normal
Whenever we switch On and off of the PAN03 by S1
、
S2 or On/Off
button or RF command, the LED will lights up 1 second and then
off.
No node ID
Under normal operation, when the Switch has not been allocated a
node ID, the LED flashes on and off alternately at 2-second
