Philco PL 1061-5 TL, Руководство пользователя

Страница: 14 / 21

Do this procedure also when
you want to do the emergency
drain.
1. Close the water tap and disconnect the
water inlet hose.
2. Disconnect the drain hose from a sink
or spigot.
3. Put the ends of the drain and inlet hose
in a container. Let the water flow out of
the hoses.
4. Set the Drain programme and let it
operate until the end of the cycle.
5. Turn the programme knob to Stop to
disconnect the appliance from the
power supply.
6. Disconnect the appliance.
WARNING!
Make sure that the temperature is more
than 0 °C before you use the appliance
again. The manufacturer is not responsible
for damages caused by low temperatures.
TECHNICAL DATA
Dimension Width/ Height/ Depth/ To-
tal depth 400 mm/ 890 mm/ 600 mm/ 600 mm
Electrical connection Voltage
Overall power
Fuse
Frequency 230 V
2300 W
10 A
50 Hz
Level of protection against ingress of solid particles and
moisture ensured by the protective cover, except
where the low voltage equipment has no protection
against moisture IPX4
Water supply pressure Minimum
Maximum 0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Water supply
1)
Cold water
Maximum Load Cotton 6 kg
Energy Efficiency Class A+
Spin Speed Maximum 1000 rpm
1)
Connect the water inlet hose to a water tap with a 3/4'' thread.
TROUBLESHOOTING
WARNING! Refer to Safety
chapters.
Introduction
The start of the appliance does not occur or
it stops during operation.
First try to find a solution to the problem
(refer to the table). If not, contact the
Authorised Service Centre.
The red indicator of button flashes.
WARNING!
Deactivate the
appliance before you do the
checks.
33