Philco PD 860, Руководство пользователя

Страница: 10 / 108

EN - 8
03/2011 Copyright © 2011, Fast ČR, a. s.
Cold water supply connection
Connect the water supply hose to the cold water inlet with a 3/4" thread and check that you have tightened
it properly. If the hoses are new or have not been used for a long time, fl ush them out with water, to be sure
that they are clean inside with all dirt removed. If you do not do this, you risk clogging up the water inlet and
damaging the appliance.
Hot water supply connection
You can also connect hot water to the dishwasher (supplied by the central system, heated by the heating
system), if the water temperature does not exceed 60 °C. This will shorten the washing cycle by 15 minutes and
the washing effi
ciency will be slightly reduced.
The connection must be carried out in the same way as for the cold water.
WARNING!
To prevent water from staying in the hose, close the water inlet into the dishwasher.
(This does not apply to dishwashers with the aqua-stop function.)
Connecting the drain hose
Insert the drain hose into the waste water pipe with a minimum diameter of 4 cm or leave it
lying in the sink and ensure that it is not bent or dented. Use a special plastic bracket supplied
with the appliance. The hose must be at a height of 40 to 100 cm above the ground. The loose end of the hose
must not be submerged in water so that reverse water fl ow does not occur.
Hang the drain hose using one of the methods A, B, C.
Front part
NOTE:
The hose must be at
a height of 40 to 100
cm above the ground.
The loose end must
not be submerged in
water.
Drain hose
Sink
Ø 40 mm
MIN 400 mm
M
A
X 1000 mm
Hang the bracket directly next to the sink.
Drain hose bracket
Draining water
•
Connect the drain hose. The drain hose must be properly attached so that water does not leak. Check that
the hose is not knotted up or pinched.