Philco PD 1562 W, Руководство пользователя

Страница: 27 / 40

EN - 25
Copyright © 2017, Fast ČR, a. s. 06/2017
NOTE:
If operate from step 1 to step 2, the fi lter system will be removed; while operate from step 2 to step 1, the
fi lter system will be installed.
Filter assembly
For best performance and results, the fi lter assembly must be cleaned. The fi lter effi ciently removes food
particles from the wash water, allowing it to be recirculated during the cycle. For this reason, it is a good idea
to remove the larger food particles trapped in the fi lter after each wash cycle by rinsing the semicircular fi lter
and cup under running water. To remove the fi lter assembly, pull on the cup handle in the upward direction.
The entire fi lter assembly should be cleaned once a week. To clean the coarse fi lter and the micro fi lter, use a
cleaning brush. Then, reassemble the fi lter parts as shown in the fi gures above and reinsert the entire assembly
in the dishwasher, positioning in its seat and pressing downward. The dishwasher must never be used without
the fi lters. Improper replacement of the fi lter may reduce the performance level of the appliance and damage
dishes and utensils.
WARNING!
Never run the dishwasher without the fi lters in place. When cleaning the fi lters, don’t knock
on them. Otherwise, the fi lters could be contorted and the performance of dishwasher could be
debased.
Cleaning the Spray Arms
It is necessary to clean the spray arms regularly for hard water chemicals will clog the spray arm jets and
bearings.
To remove the spray arms, screw off the nut clockwise to take out the washer on top of the spray arm and
remove the arm. Wash the arms in soapy and warm water and use a soft brush to clean the jets. Replace them
after rinsing thoroughly.
Caring for the Dishwasher
To clean the control panel, use a lightly dampened cloth then dry thoroughly.
To clean the exterior, use a good appliance polish wax.
Never use sharp objects, scouring pads or harsh cleaners on any part of the dishwasher.