11
1. Shade:
To protect the fluorescent lamp.
2. Door:
The door can be opened to 130 degrees approx. The door is sealed securely to the cabinet
by the magnetic gasket when it is closed.
Condensation may occur at the inner side of the door when a lot of damp material stored.
3. Door switch:
To prevent the air from escaping by stopping the air circulating fan when the door is
opened.
4. Glass window:
3-layer heat-absorbing glass to shut out the heat.
5. Shelf:
The location (height) is adjustable according to the item size to be stored.
In case of MIR-254, do not change the position of the lowest shelf or do not remove the stainless panel
on the lowest shelf to keep original airflow inside the chamber.
6. Leveling foot:
Use these bolts to adjust the height and level the unit for installation.
7. Evaporating tray:
The drained water resulting from the defrosting is accumulated and evaporated
automatically in this tray. (Page 49)
8. Frost check opening:
Check the frost on the condenser through this opening.
9.
Access port:
This port allows cables to be passed into the cabinet.
Note:
Be sure to set the rubber stopping to the hole for measurement (placed at the left side) as it was when
passing cables for measurement and power cords through it.
Be sure to replace the cap after take out cable or, the inside temperature cannot complete down, and
frost may accumulate outside the port surroundings.
10. Air circulating fan:
Fan is installed inside the duct. Do not insert anything into the duct.
11. Drain port:
Use this port when the chamber is washed with water. Always cover the port with cap
when no use.
12. Switch box:
Power switch, remote alarm terminals, and glow starter are placed.
13. Control panel:
Temperature control, alarm setting, program setting are available through the
control panel. The temperature indicator is attached on the control panel.
14. Glass protective plate:
This is prevented from glass cracking. Use shading glass protective plate
(sold separately) (MIR-154BP/254BP) when shading the window for observation
.
15. Dew saucer:
To hold the dew that adhere to inside of the door.
16. Caster (MIR-254 only):
To facilitate the moving of the cabinet.
Note:
As for the unique features of this product, reducing compressor vibration and reversible door fitting,
please contact our sales representative or agent.
When MIR-154’s are stacked, the compressor vibration reduction is not available for both units.
