ENGLISH
ENGLISH
11
DRAIN BODY INSTALLATION
10
12
10 HOSE CONNECTION
From underneath sink, push Center Connector (
10A
) onto receiving Tube (
10B
), until
unable to push any further. Pull down on Center Connector (
10A
). If the housing and
the Inner Collet (
10C
) separate slightly but do not pull off receiving Tube (
10B
), the
connection is secure.
To remove, push up on Center Connector (
10A
) holding plastic Collet (
10C
) in place,
pull down on Center Connector (
10A
) until Tube (
10B
) is free.
Slide the End Connectors (
10D
) with arrow (
10E
) pointing up onto the Valve Bodies
(
10F
). Push the End Connectors (
10D
) all the way up until completely seated. Be
careful not to damage O-Rings (
10G
).
11 WATER SUPPLY CONNECTIONS
First, thread Inlet Connectors (
11A
) into Water Supply Lines (
11B
). Then, insert Inlet
Connectors (
11A
) into Valve Bodies (
11C
).
Hot water supply lines go into left inlet.
Cold water supply lines go into right inlet. (
Supply lines not included
). Please follow
manufacturer’s instructions when installing supply lines. Next, insert Clips (
11D
) into
Valve Body Holes
(
11E
), to secure unit.
WARNING:
Do not twist Inlet Connectors (
11A
) once installed!
12 POP-UP INSTALLATION
Install and adjust Pop-Up (
12A
) using separate instructions supplied with the Pop-Up
assembly.
4
HOT
COLD
12A
10B
10B
10A
10D
10F
10F
10G
10G
10E
10D
10A
10C
10B
10A
10A
10C
11A
11D
11D
11E
11D
11A
11B
11B
11C
11C
