ENGLISH
ENGLISH
8
9
7
7 HANDLE INSTALLATION
Thread Valve Adapters (
7A
) onto the Valve End Bodies (
7B
) and tighten so that the
Valve Adapters (
7A
) sit on the surface of the Valve Body Washers (
7C
).
Place Plastic
Seal Rings (
7D
) against the bottom of Handle Hubs (
7E
). Connect Handles (
7F
) onto
Valve Adapters (
7A
).
Be sure Valves and Levers are in the “OFF” position. Secure handles by holding the Lever
(
7G
) in place and tighten Handle Hubs (
7E
) by rotating them in a clockwise direction. To
remove handles, rotate
Handle Hubs (
7E
) in a counterclockwise direction.
8 SPOUT INSTALLATION
Insert Lift Rod (
8A
) into hole at the back of Spout (
8B
). Place Plastic Seal Ring (
8C
)
against the bottom of Spout Body (
8D
). With Spout (
8E
) facing forward, carefully
install the Lift Rod (
8A
), Shank (
8F
) and receiving Tube (
8G
) through the center hole
of sink (
8H
).
9 SECURING FAUCET
From underneath sink, secure the faucet by placing the Metal Washer (
9A
) and the Long
Nut (
9B
) (
7/16
hex.) onto the Mounting Post (
9C
). Make sure that the bumps on the
Metal Washer (
9A
) are facing up. Tighten using a
Slotted screwdriver or an adjustable
wrench until the faucet is firmly connected to the sink.
Do not over tighten!
3
7F
8E
7F
7D
7A
7E
7B
7E
7A
7C
7G
7E
7C
7B
7D
9C
9B
9A
8A
8B
8G
8A
8D
8H
8F
8C
