ENGLISH
ENGLISH
3
5
6
4
2
FAUCET INSTALLATION
Thank you for purchasing this Price Pfister product. All Price
Pfister products are carefully engineered, and factory tested
to provide long trouble-free use under normal conditions. This
product is easy to install using basic tools and our easy to follow
illustrated instructions. If you have any questions regarding this
product, call 1-800-Pfaucet (1-800-732-8238).
1 BEFORE PROCEEDING
WARNING:
Read all the instructions completely before proceeding. Price Pfister
recommends calling a professional if you are uncertain about installing this product!
This product should be installed in accordance with all local and state plumbing and
building codes.
NOTE: If installation surface depth is thicker than 1
1
/
2
”, order spare part
number 971-086.
2 SHUT OFF WATER SUPPLY
Locate water supply inlets and shut off the water supply valves. These are usually found
under the sink or near the water meter. If you are replacing an existing faucet, remove
the old faucet from the sink and clean the sink surface thoroughly.
3 TOOLS RECOMMENDED
• PTFE Plumber's Tape
• Plumber's putty
• Slotted screwdriver
• Adjustable wrench
• Pliers
• Flashlight
• Cloth
Your installation may require new supply lines and / or shut-off valves or other additional
tools.
4 VALVE BODY PREPARATION
First, remove Clip (
4A
) then remove Inlet Connector (
4B
) from Valve Bodies (
4C
) and
save. Next, remove Locknut (
4D
), and Square Washer (
4E
) from Valve Bodies (
4C
)
and save.
5 VALVE BODY ATTACHMENT
From above sink, insert Valve Bodies (
5A
) through Mounting Holes (
5B
). The HOT valve,
with Red Ring (
5C
), should be positioned to the left side of the spout.
6 SECURING VALVE BODY
Before proceeding, Valve Stems (
6A
) are to be set in the closed position. From
underneath sink, place Square Washer (
6B
) onto Valve Shank (
6C
) and tighten loosely
with Mounting Nut (
6D
). Temporarily place Handle (
6E
) onto Valve Stem (
6A
) to make
sure the handle levers are properly aligned to sink. Remove Handle (
6E
) and tighten
Mounting Nut (
6D
) until Valve Body (
6F
) is firmly secured to sink.
Do not use handles (
6E
) to tighten or to rotate Valve Bodies (
6F
)!
2
4A
4E
4C
4D
4B
5A
5A
5B
5B
5C
6A
6B
6C
6C
6F
6F
6B
6D
6D
6A
6E
6E
