PRIMARY TRANSMISSION
12
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
Removal of the driven pulley
- Lock the clutch drum (1) with the pin wrench
P/N 752237.
- Remove the nut (2).
- Remove the clutch drum and the clutch and
drive pulley assembly.
Tightening torque: 45 Nm.
Changing the drive pulley bearings
- Remove the holder (1) and its 3 plastic
guides (2).
- Remove the moving flange (4) 6 bearings (3).
The bearings must be changed if they
show major signs of wear.
The guides shall be replaced if they
show signs of wear.
Checking the drive belt
- Measure the width of the belt (A).
Minimum width: 17.5 mm.
- Make sure the belt is not cracked.
1
2
752237
4
3
2
1
2
A
