Ce document est la propriété de Peugeot Sport et ne peut être reproduit ou communiqué sans autorisation.
This document is the property of Peugeot Sport and may not be copied or circulated without permission.
45
207 Spider Technical Instructions
NOT 207 SPI-80
Engine
Drain/purge the circuit:
To drain the cooling circuit, disconnect the 2 radiator hoses located at the outside of
the car (A and B) as well as the water pump input hose (C). You should drain
practically all the coolant from the system.
When reassembling, make sure that the guide bearings are tightened properly,
dismantle the drain hose from the left-hand radiator (as shown in the photo below)
and then refill the circuit through the degassing tank until the liquid comes out
through the drain (with no air). Close the drain and refill the degassing tank. Start the
engine and allow it to heat to the normal temperature, as you gradually fill the
container as it empties. When you reach the point where the level remains the same
and does not lower, fill it to the mark on the container.
Tuyau de purge
01
Ed. :
Содержание 207 Spider
Страница 1: ...TECHNICAL INSTRUCTIONS...
