PETTIBONE Extendo 1032, Руководство оператора

Страница: 112 / 120

MaINTENaNCE
104 Extendo and Traverse Operation and Maintenance Manual
800-GO-PETTIBONE
Transmission Oil Change
Note: Transmission oil should be changed with
the transmission warm. Never dispose of
transmission oil by pouring it out on the
ground or pouring it down a drain. Contact
the local EPa office or the nearest dealer for
proper disposal information.
Position a container beneath the oil drain 1.
plug, located on the center of the side of the
transmission.
Remove the plug and allow the oil to drain into 2.
the container. Install the drain plug.
fill the transmission to the proper level shown 3.
on the dipstick.
With the transmission in NEUTRaL, start 4.
the engine and check the oil level on the
transmission dipstick.
Dispose of transmission oil in a manner 5.
prescribed by the EPa.
Transmission Drain Plug 1 –
Changing Transmission Oil figure 59.
Transmission filter Element
Replacement
With the engine shut off, place a container 1.
beneath the transmission filter, located at the
right front of the engine compartment.
Using a filter wrench, remove the filter element. 2.
apply a light coat of transmission fluid to the 3.
surface of the element’s gasket.
Install element onto filter base and hand tighten 4.
only.
start engine and check for leaks. Tighten 5.
element if leaking.
axle Lubricant Change
NOTICE: The Environmental Protection agency
has established guidelines for lubricant
disposal. Contact the local office of the EPa or
the nearest axle manufacturer distributor for the
proper disposal procedure.
Position a container beneath the differential 1.
drain plug, located on the underside, center of
the axle.
Remove the drain plug and allow lubricant to 2.
drain into the container.
after the axle has drained, install the drain plug 3.
and remove both of the high lubricant level
inspection plugs.
fill the axle through both of the high lubricant 4.
level plug openings until the lubricant level is
even with the bottom of the opening. Install the
plugs.
To drain a planetary:
Park the forklift so that the drain plug on the 1.
planetary is in the lowest position.
Remove the plug and allow the planetary to 2.
drain.
1