B. Interference from Other Trainers
To prevent external interference from other trainers, the Sport Dog
Trainer can be adjusted to one of sixteen (16) User Identification Codes.
This code must be the same in both the transmitter and receiver in order
for the Sport Dog Trainer to function properly.
Receiver switches #1 through #4 are used to set the User Identification
Code. Refer to Figure 12 to locate the switches inside the receiver.
S1 S2 S3 S4 S5 S6 S7 S8
Receiver switches that change the
User Identification Code in the receiver.
Figure 12
Figure 13 below shows an example of how to set the User Identification
Code in both the transmitter and receiver. The "on" position reflects the
switch being flipped towards the battery compartment. The "off" position
reflects the switch being flipped towards the components located in the
receiver.
Remember the code you choose must match in both the
receiver and transmitter!!!
In other words, if switch #2 in the receiver
is flipped to the "on" position, switch #2 in the transmitter must also be
flipped to the "on" position.
S1 S2 S3 S4
Figure 13
Off
On
13
400-158-11/B
5/4/00, 10!32 AM
14-15
