G. Turning the Sport Dog Receiver On/Off
The Sport Dog Receiver must be turned on before beginning any training.
• Turning On
To turn the Receiver on, locate the white dots on both the transmitter
and receiver. Then place the white dot on the transmitter unit against the
white dot of the receiver unit, hold them together for three (3) seconds,
and separate. Upon separating, the receiver will perform two operations:
1) the speaker, located inside the receiver, will emit a short beep and 2)
the LED will be solid green in color for three (3) seconds and then begin
to flash approximately every second. These two functions will indicate
that the receiver is now ready to receive signals from the transmitter.
• Turning Off
When the Sport Dog Receiver is turned on and not in use, the life of
the battery is greatly reduced. Thus, it is recommended that you turn off
your receiver when practical.
To turn the Receiver off, locate the white dots on the transmitter and
receiver again. Slowly connect the white dots, hold for three (3) seconds,
and separate. Upon separating, the receiver’s speaker will emit a long
beep and the LED, located on the receiver, will change from a flashing
green to solid red in color and then turn off.
3. Using the System
A. Testing the System
With an activated receiver collar, the Sport Dog Trainer can be tested
to verify it is functioning properly. We recommend that you test your system,
before beginning any training, to ensure that you get the desired results
from your Sport Dog Trainer.
To begin, loosen the
probes and place the test
light leads on the contact
probes as shown in Figure
10. Once the test light
leads are placed around
each of the two studs,
tighten the two probes so
that the test light
is secure.
Figure 10
9
400-158-11/B
5/4/00, 10!32 AM
10-11
