I. Introduction
Thank you for purchasing the Sport Dog Trainer. We at PetSafe
believe that you have just purchased one of the finest products for training
your dog. Be sure to read this entire guide and the Training Booklet
before you start working with your dog. If you have any questions
concerning this or any other trainer, please feel free to call our Customer
Service Department at 1-800-732-2677 (M – F 8AM – 7PM, Sat 9AM –
5PM & Sun 1AM – 5PM EST) or visit our website at www.petsafe.net.
The Sport Dog Trainer comes preset from the factory. Simply insert the
batteries in the transmitter and receiver and you are ready to begin training,
the PetSafe way.
Although the Sport Dog Trainer is preset, we at PetSafe understand that
each dog is different. This manual will help you customize the Sport
Dog Trainer to your specific needs. This is accomplished by making the
following simple adjustments:
1.
Select the correct intensity level for your dog (preset to low intensity level).
2.
Adjust your Sport Dog Trainer to a specific User Identification Code
to prevent outside interference.
II. Sport Dog Trainer Quick Guide
The Sport Dog Trainer is simple and easy to use. Follow these 4 easy
steps. Refer to the Table of Contents for a detailed discussion explaining
each of these steps.
Step 1
– Insert the batteries in the transmitter and receiver. With the
screwdriver provided in the Sport Dog Trainer kit, loosen the screws in
the battery door of the transmitter and cover of the receiver.
Insert two (2) 9 volt alkaline batteries in the transmitter and one (1) 9
volt alkaline battery in the receiver. Replace the battery door and cover,
and tighten the screws for both the transmitter and receiver.
Step 2
– Activate the receiver collar. Place the white dot on the transmitter
unit up against the white dot of the receiver unit, hold them together for
three (3) seconds, and separate to turn on the receiver collar. Upon separating,
the receiver’s speaker, located inside the receiver, will emit a short beep.
Also, the receiver’s LED will be solid green in color for three (3) seconds
and then begin blinking.
Step 3
– Install the transmitter and receiver antenna. Hand tighten the
short antenna to the antenna mount on top of the transmitter. Hand
tighten the longer, flexible antenna to the antenna mount located on the
side of the receiver.
Step 4
– Using the System. Pressing any of the buttons causes the receiver
to deliver a momentary or continuous stimulation. If any of the stimulation
buttons are pressed for less than two (2) seconds, the receiver will deliver
a momentary stimulation. Conversely, if a stimulation button is pressed
longer than two (2) seconds, the receiver will deliver a continuous stimulation
for as long as the button is held down.
1
ENGLISH
400-158-11/B
5/4/00, 10!31 AM
2-3
