10
1-800-732-2677
To assure a proper fit, please follow these steps:
1. Using the edge of the Test Light Tool, turn the battery door
to the OFF position.
2. Start with your pet standing comfortably (
4A
).
3. Place the Receiver collar on your pet so that the PetSafe
®
logo is facing
your pet’s chin. Center the Contact Points underneath your pet’s neck,
touching the skin. If your pet has a long or thick coat then it may be
4A
necessary to trim the hair around the Contact Points to make sure that contact is consistent.
Note: The Receiver Collar comes with Short Contact Points. Long Contact Points are
available and can be purchased through the Customer Care Center.
4. Adjust the tightness of the Receiver Collar to fit your
pet’s neck. Check the tightness of the Receiver Collar by
inserting one finger between the end of a Contact Point
and your pet’s neck. The fit should be snug
but not constricting (
4B
).
5. Allow your pet to wear the Receiver Collar for several
minutes then recheck the fit. Check the fit again as your
pet becomes more comfortable with the Receiver Collar.
6. Once you are satisfied with the fit of the Receiver Collar
then you may trim any excess collar strap as follows (
4C
):
a. Mark the desired length of the Receiver Collar with a pen.
Allow for growth if your pet is young or grows a thick
winter coat.
b. Remove the Receiver Collar from your pet and
cut off the excess.
4B
4C
c. Before placing the Receiver Collar back onto your pet, seal the edge of the cut collar by
applying a flame along the frayed edge.