Petite & Mars Grand II, Руководство пользователя

Страница: 42 / 47

42
CLEANING
The lining of the stroller and the pram body cannot be removed.
Clean the fabric parts using a wet sponge and neutral soap. Clean the plastic parts
periodically using a wet cloth. Dry the metal parts if they come into contact with water
in order to avoid the formation of rust. Do not use solvents or abrasive products.
The washing symbols and relative meanings are indicated below:
MAINTENANCE
Lubricate the removable parts with dry silicon oil if needed. Check the state of wear
of the wheels on a regular basis, and keep them clean from dust and sand. Make sure
that all plastic parts that slide on the metal tubes are clean from dust, dirt
and sand, in order to avoid frictions that may compromise the optimal performance
of the stroller. Keep the stroller in a dry place.
FIRST ASSEMBLY OF THE STROLLER
1. Take the frame and all accessories out of carton. Use the right hand pull
up the locking hook. Lift the handlebar upwards until „click“ by left hand
2. Place rear axle into stroller frame. You should hear snap. Ensure that the brake
is facing the rear. Fig 2.
3. Place the rear wheels into axle pins. When you adjusted properly you should hear
„click“. Make this action for the second front wheel too.
IMPORTANT:
Inflate tires of rear wheels max. 35 PSI (240 KPa) / (2.4 BAR),
be careful not to exceed the specified value.
4. Place the front swivel wheels into front housing. When you adjusted
properly you should hear „click“. Make this action for the second
front wheel too.
WARNING: Before using the stroller, make sure that the wheels are well secured
to the structure. Fig 4.
5. The stroller is equipped with front swivel/fixed wheels.
DO NOT WASH
DO NOT BLEACH
DO NOT TUMBLE DRY
DO NOT IRON
DO NOT DRY CLEAN