Perreaux eloquence 250i, Руководство пользователя

Страница: 13 / 34

3.5mm (
8
”) plug. The trigger output voltage is 12V DC when the amplifier
is not in standby and is 0V DC when in standby.
The trigger output plug must meet the specifications shown below:
Sleeve: GND
Tip: Signal
7 IR Input
The IR (infrared) input allows your éloquence 250i to receive un-modulated
commands from home automation systems or other components.
The IR input uses a stereo 3.5mm (
8
”) plug, and accepts voltages of 0V DC
up to 12V DC. The plug must meet the specifications shown below:
Sleeve: No connection
Ring: GND
Tip: Signal
Using an external IR receiver module (for example, Xantech 490-30 Micro
Link™ IR receiver) allows the amplifier to be placed inside a cabinet or
outside the normal line-of-sight of the remote control. The plug must meet
the specifications shown below:
Sleeve: +12VDC
Ring: GND
Tip: Signal
Note: Do not use a mono 3.5mm ( 8 ”) plug, this may cause damage to the
IR input.
2 Amp In
The unbalanced (RCA) amp in inputs allow direct connection to the power
amplifier sections of your éloquence 250i when used in conjunction with the
Separate function (see Separate, page 24).
3 Pre Out
The unbalanced (RCA) preamp outputs provide a single-ended preamp level
audio signal for connection to an external power amplifier or active subwoofer.
4 Tape Out
The unbalanced (RCA) tape outputs provide a single-ended line level audio
signal, suitable for recording from the selected source input. This output is
disconnected when INPUT 5 is selected; to prevent any potentially damag-
ing feedback loops if the tape output is connected to this input.
5 Trigger Input
The trigger input allows your éloquence 250i integrated amplifier to be
brought in and out of standby by a remotely connected device; for example,
another audio component or a home automation system. The trigger input
uses a mono 3.5mm (8”) plug and accepts voltages of 0V DC up to 12V
DC. A trigger voltage between 3V and 12V DC will bring the amplifier out of
standby and it will enter standby when the trigger voltage is 0V DC.
The trigger input plug must meet the specifications shown below:
Sleeve: GND
Tip: Signal
6 Trigger Output
The trigger output allows your éloquence 250i to control the standby state
of a remotely connected device. The remote trigger output accepts a mono
Sleeve Ring Tip
Sleeve Ring Tip
Sleeve Tip
Sleeve Tip
10