Permobil C350, Руководство по обслуживанию

Страница: 39 / 68

39
Lights module and ICS master module
ICS master module with cover removed
ICS master module loose in its holder
ICS master module
(Only applies to chassis with R-net.)
The wheelchair seat may be equipped with an ICS
control system, and if so, the seat is controlled
from the system’s ICS master module. This is fit-
ted in the wheelchair chassis.
Removal
1. Raise the seat; electric seat lift to the highest
position; fixed seat tube to the service position.
See page 24. If the electric seat lift does not
work normally because the batteries are dis-
charged or the adjustment device is defective,
the seat can be raised/lowered manually. See
page 26.
2. Switch off the main power switch on the con-
trol panel.
3. Remove the chassis cover. See page 8.
4. Pull the master module straight up out of its
holder (see illustration).
5. Pull the cover off.
6. Cut off the cable ties that hold the cables and
detach the electrical connections. Note their
positions for subsequent fitting.
Assembly
Assemble in the reverse order.
The lights module is held in place
with two screws.
Lights module
(Only applies to chassis with VR2 and lights.)
Removal
1. Switch off the main power switch on the con-
trol panel.
2. Remove the chassis cover and rear battery
cover. See page 8.
3. Disconnect the electrical connections from the
lights module. Note their positions for subse-
quent fitting.
4. Remove the lights module. It is held in place
with two screws. See the illustration.
Assembly
Assemble in the reverse order.