Perle IDS-108FPP series, Руководство по установке

Страница: 14 / 20

IDS-108FPP Installation Guide 14
Connecting Power to the IDS-108FPP
1. Conductors suitable for use in an ambient
temperature of 95°C must be used for the Power
Supply Terminal.
2. Ensure the power source is off prior to connection.
3. Strip both (12AWG) wires 5mm (3/16th inch).
4. Loosen the terminal block screws and connect the
positive wire (+) into the + terminal and the negative
(-) wire into the - terminal.
5. Tighten terminal screws (0.51Nm torque).
6. Ensure the wires are securely fastened.
7. Re-insert the Terminal block connector if removed.
8. Turn on power source.
9. Check that the P1 LED is On.
10. If desired connect P2 (power source 2, beginning
again at Step 1).
11. One individual conductor for each clamping point.
Connecting PoE/PoE+ devices
•
Supports IEEE 802.3af (Type 1) and IEEE 802at-
2009 (Type 2) standards.
•
For PoE devices up to 15.4 Watts per port.
•
For PoE+ devices up to 30 Watts per port.
Connect the copper cables from each TP port (RJ-45)
on the IDS-108FPP switch to compliant Powered
Devices (PDs).
See below for RJ-45 pinouts on ports 1 through 4.