Perle IDS-108FPP series, Руководство по установке

Страница: 11 / 20

IDS-108FPP Installation Guide 11
Wall Mounting the IDS-108FPP
1. Remove the DIN-rail clip from the rear panel on the
IDS-108FPP.
2. Attach the wall mount plates to the IDS-108FPP as
shown below using the screws provided in the kit.
3. Use the wall mount plates as a guide to mark the
spots where the screws will be.
4. Drive the screws into the wall leaving about 2 mm of
the screw protruding from the wall to allow room for
sliding the wall mount panel between the wall and
the screws.
5. Fix the screws to the wall and then insert the four
screw heads through the large parts of the keyhole
shaped screw openings.
6. Pull the IDS down to lock the IDS-108FPP to the
wall mount.
7. Tighten the four screws securely to the wall.
Note: For the best results use screws that have the following
attributes:
Head diameter .5 - .6 mm
Shaft diameter 3 - 3.5 mm