8
SEBU8603-01
Safety Section
General Hazard Information
g01154809
Illustration 5
Typical example
An ether warning label will be installed on the air
cleaner or close to the air cleaner. The location will
depend on the application.
i03566024
General Hazard Information
g00104545
Illustration 6
Attach a “Do Not Operate” warning tag or a similar
warning tag to the start switch or to the controls
before the engine is serviced or before the engine is
repaired. Attach the warning tags to the engine and to
each operator control station. When it is appropriate,
disconnect the starting controls.
Do not allow unauthorized personnel on the engine,
or around the engine when the engine is being
serviced.
•
Tampering with the engine installation or tampering
with the OEM supplied wiring can be dangerous.
Personal injury, death and/or engine damage could
result.
•
Vent the engine exhaust to the outside when the
engine is operated in an enclosed area.
•
If the engine is not running, do not release the
secondary brake or the parking brake systems
unless the vehicle is blocked or unless the vehicle
is restrained.
•
Wear a hard hat, protective glasses, and other
protective equipment, as required.
•
When work is performed around an engine that is
operating, wear protective devices for ears in order
to help prevent damage to hearing.
•
Do not wear loose clothing or jewelry that can snag
on controls or on other parts of the engine.
•
Ensure that all protective guards and all covers are
secured in place on the engine.
•
Never put maintenance
fl
uids into glass containers.
Glass containers can break.
•
Use all cleaning solutions with care.
•
Report all necessary repairs.
Unless other instructions are provided, perform the
maintenance under the following conditions:
•
The engine is stopped. Ensure that the engine can
not be started.
•
The protective locks or the controls are in the
applied position.
•
Engage the secondary brakes or parking brakes.
•
Block the vehicle or restrain the vehicle before
maintenance or repairs are performed.
•
Disconnect the batteries when maintenance
is performed or when the electrical system is
serviced. Disconnect the battery ground leads.
Tape the leads in order to help prevent sparks.
•
Disconnect the connector for the unit injector that
is located on the valve cover base. This will help
prevent personal injury from the high voltage to the
unit injectors. Do not come in contact with the unit
injector terminals while the engine is operating.
•
Do not attempt any repairs or any adjustments to
the engine while the engine is operating.
•
Do not attempt any repairs that are not understood.
Use the proper tools. Replace any equipment that
is damaged or repair the equipment.