PerkinElmer TriNEST, Инструкция по эксплуатации инструмента

Страница: 19 / 34

Incubation temperature
Incubation time
Shake speed
Interval shake time
Interval rest time
Note: The interval times are in minutes and seconds whereas the incubation time is in hours and minutes.
Press the Right arrow after the Interval
rest time. The editing mode will close
and parameters values will be saved. The
program number will be highlighted.
Now you can use this program for operating the instrument
Note: Although the instrument accepts times shorter than three seconds for an active shaking period, using them may
cause errors. Times shorter than three seconds should not be used.
Operation
1. Select the program number with the selection wheel.
2. Press the Preheat button. The red LED beside it will come on. Wait until the selected temperature has been reached
and the red LED blinks.
Note: This is an optional function to pre-heat the incubation chambers
3. From the display, check that the target incubation temperature is correct and has been reached. Load plates in
holders into the instrument. The Start/Pause button will blink.
Note: Make sure all plate holders are loaded into the instrument before starting the operation. Be aware that the
instrument does not start if all the plate holders are not loaded. A single missing or not properly loaded plate holder
prevents the operation from starting
4. Press the Start/Pause button to start incubation. The timers will start to count down to zero.
Warning: If the instrument chambers are already heated and you insert a plate without starting the incubation cycle,
the plate incubates for as long as the temperature remains high enough. In this case, the instrument timer does not
take the incubation time into account.
5. To make sure that the temperature remains correct, follow the incubation temperature at the bottom of the display.
TriNEST Microplate incubator and shaker
Operating instructions
15