PerkinElmer STA 8000, Инструкция по установке и эксплуатации оборудования

Страница: 41 / 64

Install an STA 8000 . 41
Connect the Purge Gas and System Purge Gas Lines to
the STA 8000
Perform the following procedure to connect your sample purge gas and system purge gas
lines to the STA 8000 analyzer regardless of the other components in the purge gas line.
Assuming all the other components of the purge gas line are installed, you will now connect
1/8 in. Teflon tubing to the STA 8000 using a female connector.
The STA 8000 System Purge Gas (1 pc) and Sample Purge Gas (2 pcs) connectors are
mounted to the back of the analyzer.
1. Place the 1/8 in. Teflon tubing from your dry purge gas line onto the inlet labelled
System Purge ALWAYS REQUIRED.
2. Place the 1/8 in. Teflon tubing from your Sample Purge Gas line onto the inlet labelled
sample purge A.
If required, a second sample purge line (1/8 in. Teflon tubing) can be connected to the
purge B inlet.
WARNING
AVERTISSEMENT
Check that the regulated gas pressure does not exceed 90
psi (6.2 bar) before sw itching on the gas supply.
Vérifiez que la pression de gaz réglementée ne dépasse pas
90 psi (6,2 bar) avant d'allumer l'alimentation en gaz.
When using the STA 8000 in environments of high relative humidity, a mini dry box
(P/N N5202070) is recommended to prevent condensation. This acts simply to protect the
furnace from condensation, and is not connected to the dry box purge inlet.
NOTE: The dry box purge inlet is non-functional in the STA 8000.