PerkinElmer Photovac MicroFID, Руководство пользователя

Страница: 122 / 170

MicroFID Software Manual
Cause: There is a problem with the refill adapter.
Action: Contact the Service Department.
WARNING
DO NOT modify or disassemble the refill adapter! If you have any
problems, the unit must be returned for repair or replacement.
Problem: Instrument status shows “ Over” .
Cause: Rapid change in signal level. The detector
electronics have been momentarily saturated.
Action: Wait a few seconds for the status to return
to “R eady”.
Cause: The detector has become saturated.
Action: Move MicroFID to a location where it can
sample clean air. Sample zero air until the
reading stabilizes around 0. If you were
using Low Range, switch to High Range.
Calibrate the Cal Memory you were using
when the “O ver” status appeared.
Action: If you were using High Range, there may
be an electronic problem. Contact the
Service Department.
Problem: Display contrast bars are on or display is blank
Cause: Battery pack is critically low.
Action: Recharge battery pack or connect
MicroFID to the battery charger.
Cause: The battery pack is not connected to the instrument
properly.
Action: Ensure the battery pack has been aligned
correctly. Ensure the battery pack is
secured by the retainer at the rear of the
instrument. Check the screws holding the
120