Perkin-Elmer STA 6000, Инструкция по установке и эксплуатации оборудования

Страница: 36 / 84

36 . STA 6000 Installation and Hardware GuideSTA 6000 Installation and Hardware Guide
Unpacking the STA 6000
The STA 6000 consists of the following components:
•
STA 6000
•
Personal Computer
• Printer (Optional)
• Chiller (Optional)
• Autosampler (optional)
The STA 6000 comes set up to operate at voltages of 200–240 V. However, it can easily be
set up to run at voltages of 100–120 V. Follow the instructions found in the section on
selecting the correct voltage to set up your STA 6000 to the proper voltage for your
laboratory.
The STA 6000 comes wrapped in plastic and is surrounded by foam on all sides of the
analyzer. To unpack the analyzer, follow the steps below:
1. Remove the foam inserts from the box.
2. Remove the analyzer from the box.
WARNING
AVERTISSEMENT
Use the proper lifting posture w hen taking the analyzer out
of the shipping carton base. Bend your knees w hen lifting
and securely hold on to the analyzer as you lift.
Utilisez la position de levage appropriée lorsque vous retirez
l'analyseur de la base du carton d'expédition. Pliez vos
genoux lors du levage et maintenez-le bien sur l'analyseur
lorsque vous soulevez.
3. Remove the foam from all sides, resting the analyzer on its left or right side as
necessary.
4. Remove the tape and plastic from around the analyzer.
5. Remove the tape from the outer furnace lid and remove the lid. Place it to the side.
6. Remove the packing material from inside the furnace area.
7. Remove the tape from the connectors on the rear of the instrument.
It is recommended that you keep the shipping foam should the analyzer require shipment or
movement to another facility in the future.