12
PERI InSite Construction -
Data Acquisition System
Instructions for Installation and Use - Technical Cabinet with Main Unit and Nodes – Preliminary Draft –
2.1 How to use the System safely
This section provides general information about safety and intended use of The System. The
life span and the recycling of the product are also explained in this section.
General Safety Instructions:
•
The System must only be set up, started or used after reading this
Instructions for Installation and Use
and in particular the Safety Instructions in the beginning of this chapter.
•
The System should be protected from rain and other environmental conditions that can cause unwanted
situations and can reduce The System performance and life span. Although the Nodes and the
Technical Cabinet (when closed) is designed to withstand normal weather conditions it is recommended
to place the equipment shielded from rain, wind and sun if possible.
•
The System and all its parts must be used for the intended purpose as described in this
Instructions for
Installation and Use
.
•
The System is not ATEX (Atmosphere Explosive) certified therefore it must not be operated in potentially
explosive atmospheres.
•
During the operation of The System any work method that hinders the safety of The System is
prohibited.
•
The Technical Cabinet should not be placed in mud or snow, hanged in its mains cable or carrying
handle. Take care not to place the equipment where it could fall down and cause injury.
•
The System must be used under the defined working conditions in this
Instructions for Installation and
Use
.
•
All the tags, compliance information and the safety instructions on The Technical Cabinet should be
protected.
•
The System and all its parts must be installed and operated by the trained personnel.
•
In case of malfunctioning and fault The System should be repair and install correctly by the trained and
authorized personnel before further use.
The System should only be operated by skilled adult professionals. Advanced
operations shall only be done by a qualified and trained service engineer. There are
no user serviceable parts inside.
Technical life span
The System and all its parts have technical life span of 5 years.
Intended Use
The System and all its parts are designed for its intended use as described in this
Instructions
for Installation and Use
. The System must be used and installed by the trained experts and
the users must be aware with possible hazards and danger. The System is intended to use
within the EEA, therefore it applies all the industry specific and other mandatory laws of the
country where The System being used. The safety instructions in this
Instructions for
Installation and Use
must be followed by the user, the user is solely responsible for the actions
which goes beyond the intended use of The System. The manufacturer is not responsible for
any damage or unexpected results from unintended use of the equipment.