performaxopeners.com Customer Service: 1-877-436-4402
3
PREPARE GARAGE DOOR FOR INSTALLATION TOOLS NEEDED
Step Ladder
Ratchet with
1/4", 7/16" and
1/2" sockets
Level
Pencil
Screwdriver
Hack Saw
Tape Measure
Adjustable Wrench
Rubber Mallet
Drill, 3/16" and
5/16" Drill Bits
Pliers
Hammer
DO NOT RE-USE PARTS
AND WIRING FROM AN
OLD OPENER.
YOUR NEW
PERFORMAX OPENER WILL
NOT WORK IF OLD PARTS AND
WIRING ARE USED. THIS WILL
ALSO VOID THE WARRANTY.
BEFORE
beginning installation:
1. Disable locks and disengage
trolley from current opener.
2. Perform the following door test to ensure your door is balanced and in
good working condition.
Make sure garage door is fully closed before you start the installation
To test your garage door:
1. Raise and lower the door to check if there is any sticking or binding.
2. Check for loose hinges, damaged rollers, frayed cables and damaged or
broken springs.
3. Lift the door approximately halfway and release. The door should stay at
that point under proper spring tension.
Call a qualified garage door service technician if your door binds, sticks or
is unbalanced.
Note: tools shown are not included.