performaxopeners.com Customer Service: 1-877-436-4402
23
PROGRAMMING HANDHELD REMOTE CONTROL
Look in the box for:
Three Button Remote
To prevent SERIOUS INJURY or DEATH:
• Keep remote control and battery out of reach of
children.
• NEVER permit children to access door control or
remote control.
• Operate the door ONLY when it is properly
adjusted, and there are no obstructions present.
• ALWAYS keep a moving door in sight until
completely closed. NEVER cross the path of a
moving door.
To reduce risk of fire, explosion or electric shock:
• DO NOT short circuit, recharge, dissemble or heat
the battery.
• Replace with a CR2032 3 volt battery ONLY.
1. Press and release the “Learn”
button (located on back of
opener).
2. The “OK” LED will illuminate
indicating ready for
programming.
Erasing ALL remote controls from memory:
To erase ALL remote controls from memory, press and hold “Learn”
button for 3 seconds. “OK” LED will flash and beep three times
indicating all remotes have been erased from memory.
When battery of hand held
remote control is low, indicator
LED will become dim and/or
range of remote control will
decrease. To replace battery,
remove battery cover from
remote control. Replace with a
CR2032 3 volt battery.
3. Press desired button on
remote control within 30
seconds to program.
* Additional buttons on remote
can be used to program multiple
separate Performax garage door
openers*
Press and release LEARN
Beeps
30 sec
Beeps
Press and hold
LEARN 3 sec
2 x beeps
2 x flashes
WARNING
The “OK” LED flashes twice
followed by two beeps to
confirm remote has been
programmed.