18
NOTICE:
When adjusting the torque clutch make sure that the speed switch is
completely in either the LO or HI position.
CAUTION!
Do not change the torque setting when the tool is running.
LED WORkLIGHT (Fig. 10)
The LED worklight, located on the base of
the drill, will illuminate when the trigger
switch is depressed. The LED worklight
will turn off when the trigger switch is
released. This provides additional light on
the surface of the workpiece for operation
in lower-light areas.
INSTALLING BITS (Fig. 11a, 11b)
1. Lock the trigger switch by placing the
direction of rotation selector in the
OFF (center) position.
2. Open or close the chuck jaws to a
point where the opening is slightly
larger than the bit size you intend to
use.
3. Insert a drill bit.
WARNING:
Make sure to insert the
drill bit straight into the chuck jaws. Do
not insert the drill bit into the chuck jaws
at an angle and then tighten the chuck,
as shown in figure 11b. This could cause
the drill bit to be thrown from the drill, re-
sulting in possible serious personal injury
or damage to the chuck.
NOTICE:
Rotate the chuck body in the
direction of the arrow marked GRIP to close the chuck jaws. Do not use a
wrench to tighten or loosen the chuck jaws.
4. Tighten the chuck jaws securely on the bit.
REMOVING BITS
CAUTION!
Use protective gloves when removing the bit from the tool, or first
allow the bit to cool down. The bit may be hot after prolonged use.
1. Lock the trigger switch by placing the direction of rotation selector in the
OFF (center) position.
Fig. 10
LED worklight
Fig. 11b
WRONG!
13
15
17
19
Fig. 11a
(Release)
Tighten
Keyless
chuck
OPEN
GRIP
