Performance Motion Devices Magellan DK58113, Руководство пользователя

Страница: 48 / 56

Electrical Reference
48
DK58113 Developer Kit User Manual
3
3.2.11 Synch Connector (J13)
This connector provides a synch signal connection which can be used to synchronize the MC58113 with external
controllers including other MC58113s.
This connector is an unshrouded 2-position double-row male header, .1" spacing.
3.2.12 +5V Connector (J2)
This connector provides the DK58113 board with power to operate the on-card logic whenever HV power (J1) is not
provided. Note that +5V should not be provided to the board when +HV power is provided. Connecting both power
sources (+HV as well as +5V) at the same time may result in incorrect operation or damage to the DK58113 board.
The on-card switching amplifier is not operable when only +5V power is provided. The primary use of this +5V power
input is when an external amplifier is used such that on-card amplification is not needed.
3.2.13 Connector Parts Reference
The following table is supplied as a reference only.
6 HostSPIStatus This signal indicates when an SPI response is available.
7 GND Ground
8 Reset Active low reset signal for MC58113 IC.
Pin Signal Description
J13 - Synch Connector
1 Synch This pin inputs or outputs a synchronization signal that can be
used to synchronize the loop rates of multiple MC58113s with
each other or with another external source.
2 GND Ground
Pin Signal Description
J2 - +5V Connector
1 +5V +5 volts
2 +5V +5 volts
3 GND Ground
4 GND Ground
Label Connector Name Connector Part Number Connector Mate
J1 HV Power Phoenix Contact 2-circuit pluggable
terminal block p/n 1924305 Phoenix Contact 2-circuit mating
terminal, 5.08mm pitch. p/n 1912401
J3 Motor Drive Phoenix Contact 5-circuit pluggable
terminal block p/n 1924334 Phoenix Contact 5-circuit mating
terminal, 5.08mm pitch. p/n 1912430
J8 Axis 1 Feedback High density D-sub 15-position, female High density D-sub 15-position, male
J9 Axis 2 Feedback High density D-sub 15-position, female High density D-sub 15-position, male
J4 Amplifier Signal Phoenix Contact 3-circuit pluggable
terminal blockp/n 1985205 N/A
J10 SPI Atlas Bus DB-9, male DB-9, female
J12 Remote Amplifier 2 by 8 un-shrouded header, male, .1"
spacing Samtec socket, 16-position, .1’’
spacing. p/n: ISDM-08
J14 Shunt Phoenix Contact 2-circuit pluggable
terminal block, p/n 1924305 Phoenix Contact 2-circuit mating
terminal, 5.08mm pitch. p/n 1912401
Pin Signal Description