Perenio Power Link, Инструкция по установке и эксплуатации

Страница: 39 / 49

Installation and Operation Manual
for Perenio® Power Link Devices
©Perenio IoT spol s r.o. All rights reserved Doc Version: 1.4.3
Page 39 of 49
e. Plug it into the source of power in a new room;
f. In the User Account, select the Location where you want to move the
device;
g. Initiate the Power Link search by the Control Gateway /IoT Router through
the Perenio Smart application according to par. B. “CONNECTION TO
THE CONTROL GATEWAY/IOT ROUTER”.
NOTE. The User can manually disconnect the Power Link device from the Control
Gateway
/IoT Router . To do this, press and hold the Reset button on the Power
Link device until the LED flashes (It usually takes no more than 5 seconds).
NOTE. To check that the Power Link device was successfully disconnected, you
should update the list in the Devices tab (Pull the screen down until the progress
icon appears and the data is updated). If the Power Link device is disconnected,
it will disappear from the list of connected devices.
2.4 History and Push-Notifications
All notifications and other messages including changes in the status of Perenio®
devices are displayed in the “History” tab. The most important messages can be
viewed online in the “ ” notification window in your account.
The following types of notifications are available:
 (Critical) alarms (They always come as push notifications to your smartphone,
and are also displayed in the notification window, as well as in the “History” tab
of the mobile app; The indication color is red);
 Important messages (They are always displayed in the notification window and
the “History” tab; The indication color is yellow);
 Typical events (They are displayed in the “History” tab only; The indication color
is not available).
Alarms. These are the most important messages, which include notifications about
the following events:
 IoT Router battery charging is low;
 The IoT Router runs on battery;
 Motion detection by the camera;
 There is not enough space on the SD card to continue recording video;
 Change of the camera status to “Offline”;