EWL17
23/11/2009
©
Velleman
®
nv
3
5.
Replacing the light bulb
•
To install/replace the lamp, first unplug the device from the mains outlet.
•
Be aware that the housing might become hot during operation – allow enough time for the device
to cool down before touching it.
•
Open the front cover by loosing the 4 screws.
•
DO NOT TOUCH
the bulb with bare fingers – use a piece of cloth or wear gloves.
•
Only use bulbs that are suited for this device
. Refer to the “
Technical Specifications
”
below.
•
After replacing the bulb, close the front cover firmly with the 4 screws. Make sure that the seal
between cover and housing is still intact and positioned correctly.
•
Re-apply mains power to the device.
6.
Technical specifications
power supply
230VAC / 50Hz
power consumption
300mA / 32-36W
luminance 2200
lux
cable length
5m
height
235 x 370 x 300mm
weight 1850g
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device.
For more info concerning this product, please visit our website
www.perel.eu
.
The information in this manual is subject to change without prior notice.
©
COPYRIGHT NOTICE
This manual is copyrighted. The copyright to this manual is owned by Velleman nv.
All worldwide rights reserved.
No part of this manual may be copied, reproduced, translated or reduced to any electronic medium or otherwise without the
prior written consent of the copyright holder.
