Mounting the Phoenix
Caution: The touchpanel consists of a plastic film covering glass. Use care when handling the Phoenix during
mounting to avoid damage to the touch panel. Physical damage to the panel is NOT COVERED BY THE
WARRANTY.
Add Mounting Base to Unit
Lay the Phoenix on a flat surface with padding to protect the touchpanel (the bag the unit is shipped in works well for this).
If you ordered a Keyboard mount, lay one of the flanged plates from the keyboard mount on the back of the unit with the
flanges bent towards the unit. The ball on the base is offset from the center of the base so consider which way the offset
should be arranged for the mounting distance needed. Use the four 1/4-20 x 1/2” screws included with the unit and using a
with a 5/32 hex driver (not included) tighten sedcurly.
Figure 4
without keyboard mount
Figure 5
with keyboard mount
Assemble the mounting arm
The mounting arm comes unassembled. Put the parts together as shown in Figure xx and tighten the nut 2-3 turns. Then
place the arm on the ball of the base on the back of the unit with the spring side of the arm furtherest away from the unit
Figure 6
Figure 7
