PERCo TTR-10A Series Скачать руководство пользователя

Страница: 17 / 34

Assembly & Operation Manual

Pass elements for “PASS A”, “PASS B”, “Ready”, “Detector” - relay contacts (Fig. 11) with the
following signal characteristics:

maximum commutation DC voltage

....................................................................................... 42V

maximum commutation current ............................................................................................ 0.25A
closed contact resistance ....................................................................................... max 0.15

Ohm

Pass elements for

«Alarm» and «Battery» – relay contacts (Fig. 11) with the following characteristics:

maximum commutation DC voltage ........................................................................................ 30V
maximum commutation AC voltage

........................................................................................ 42V

maximum commutation AC/DC current

....................................................................................... 3

closed contact resistance ....................................................................................... max 0.15

Ohm

5.4.2 Intrusion detector and siren

Caution!

Installation of the intrusion detector is made in accordance with the passage area layout and
climatic resistance of the detector. No intrusion detector installation inside the turnstile post
is possible.

The intrusion detector is connected to the

connector block contacts, and the siren is connected

to the

connector block on the interface board (10) according to the connection layout (Fig. 7

and 17). There should be normally closed contacts on the intrusion detector. In case the intrusion
detector is not connected, it is necessary to set a wire jumper between the contacts

DKZP1

and

GND

of the

connector block. The jumper is installed upon delivery.

The siren is connected to the

Alarm 1, Alarm 2

and

GND

contacts and +12V of the

XT1.H

connector

block. The parameters of the alarm relay output signals “Alarm” are indicated in Sect. 5.4.1

If the turnstile is locked (the command “

Always Locked

” or “

Both passage directions are locked

” is

given, Tables 5 and 6) the

DKZP1

input is activated and a signal comes from the intrusion

detector, the “Alarm” output is activated. The "Alarm" output is disabled 5 sec. after activation or by
executing of any received command.

The signal from the intrusion detector is ignored for the period

of authorized unblocking of the turnstile in either or both directions.

Note:

The control signal from the intrusion detector does not activate the

ALARM

output if the

turnstile turning mechanism is unlocked in one of the directions or was blocked less than
3 sec. ago.

A signal about the intrusion detector current state is always transmitted to the

DETECT

contacts

(relay "Detector") and

COM

of the

connector block on the interface board (Fig. 7).

The parameters of the “Detector” relay output signals are indicated in Sect. 5.4.1.

5.4.3 Remote indicators

Remote indicators for corresponding passage directions are connected to

X3 (LIGHT)

connector

blocks -

NO1, C1, NC1, NO2, C2, NC2.

The relay “Light A” (“Light B”) is activated (voltage is

supplied to its winding) when the green arrow corresponding to this direction of passage is lit on
the LED indication unit, and normalized (voltage is not supplied to its winding) when it is not lit. The
fact of “Light A” and “Light B” relays operation can be determined by the state of the indicators that
are installed near the indicated relays (Fig. 7) (this indication works when the

XP2 (+12LED)

jumper

is installed).

Pass elements for “Light A” and “Light B” - relay transfer contacts (Fig. 12) with the following signal
characteristics:

maximum commutation DC voltage

....................................................................................... 30V

maximum commutation AC voltage.........................................................................................  42V
maximum commutation AC/DC current.....................................................................................  3A
closed contact resistance .......................................................................................  max 0.15

Ohm