PERCo TTR-10A Series, Руководство по сборке и эксплуатации

Страница: 16 / 34

TTR-10A electromechanical tripod turnstile
In the pulse control mode control over the turnstile with an ACS controller is similar to that with the
RC-panel.
For organizing single passes in the potential control mode, it is recommended to remove the low-
level control signal upon passage through the turnstile, i.e. at the beginning of the corresponding
direction
PASS signal.
5.4 Additional devices connectable to the turnstile
5.4.1 Relay outputs
Connection to the control board relay outputs is performed through the corresponding contacts of
the
X1 and X5 connector blocks on the interface board. The following relay outputs are installed:

«Alarm» : contacts A1 and A2 (Sect. 5.4.2);

«PASS A» : contacts Pass A and C (Sect. 5.2.7);

«PASS B» : contacts Pass B and C (Sect. 5.2.7);

«Not ready» : contact READY and COM (Sect. 5.5);

«Detector» : contacts DETECT and COM (Sect. 5.4.2);

«Battery»: contacts LV1 and LV2 (Sect. 5.5) .
Relays “PASS A” ( Pass A and C contacts), “PASS B” ( Pass B and C contacts), “Detector” and “Not
ready” ( DETECT, READY and COM contacts) have normally open contacts when the power is off.
Moreover, the C and COM contacts common to these relays are not connected to the turnstile
power supply minus.
Relays “Alarm” (contacts A1 and A2 ) and “Battery” ( LV1 and LV2 ) have normally open contacts
when the power is off.
In the initial (inactive) state when the power is on, the “PASS A” and “PASS B” relay contacts are
closed (voltage is applied to the relay coil), and the “Detector”, “Not ready”, “Alarm” and “Battery”
relay contacts are open (voltage to relay coil is not applied).
The actuation / release of the “PASS A”, “PASS B”, “Ready”, “Detector”, “Alarm” and “Battery”
relays can be determined by the light-on / off of the green indicators installed near the indicated
relays (Fig. 7) (indicators work with the
XP2 jumper installed).
Figure 11. Pass elements PASS A, PASS B, Ready, Det Out and Alarm
15