TTR-10A electromechanical tripod turnstile
Fix the post to the installation surface with four PFG IR10-15 (SORMAT, Finland) anchor
bolts.
Put the cables inside the post and route them through the top outlets. Secure the cables
inside the post with cable ties.
Control the verticality of the post using the level.
Put the front panel back and fix it with screws.
5. Remove the housing (1) from the turnstile base:
Unscrew the four fixing screws on the housing (7) using the SW3 Allen key. The screws are
located on the lower surface of the turnstile base, the hub side.
Lift the turnstile housing by the lateral faces to half the height of the turnstile base.
Separate the indication cable (8), that connects the LED indication unit (2) and the interface
board (10).
Detach the housing carefully and put it on a plain and steady surface.
6. Route the cables into the corresponding hole in the turnstile base, install the turnstile base on
the bracket pins and secure it with M8 nuts using an S13 wrench (10Nm tightening force). Seal
the turnstile housing cable entry with isolon (polyethylene foam) or other.
Caution!
Fix and mount the turnstile after laying all the cables in the cable ducts. Be careful and
prevent the turnstile from falling before it is fixed.
7. Connect the power cable from the turnstile power supply to
X1
connector block on the control
board (9). Connect the ground wire to the grounding point (13) (Fig. 3). For connection ease,
unscrew the two fixing screws a few turns on the sides of the interface board and push it
towards you until it stops.
8. Connect the RC-panel (WRC or ACS controller) cable to the
X2
connector block on the
interface board (Fig. 17).
9. Install and connect optional equipment if necessary: intrusion detector and siren;
Fire Alarm
emergency unblocking device, remote indicators, etc. (Fig. 17).
10. Check serviceability and accuracy of all the electrical connections in accordance with the
diagram in Fig. 17. Slide the interface board back into place and tighten the lock screws.
Carefully lay and secure all connected cables on a holed horizontal shelf with the supplied
cable ties.
11. If it is necessary to set the turnstile to potential control mode, set the switch
No. 1 SA1
(SETUP)
on the interface board to the
OFF
position.
12. If the turnstile is installed in a vehicle, then set the barrier arms turn effort to “hard” - set the
switch
No. 2 SA1 (SETUP)
on the interface board to the
ON
position.
Note:
The “hard” value of barrier arms turn effort is used when installing the turnstile in vehicles
in order to compensate for possible jolting and vibration of the barrier arms during
movement and causeless alarm activation, as a result. Also, this mode should be used if
the turnstile is used outdoors in northern regions to compensate for grease thickening at
low temperatures. In all other cases, it is recommended to use the “soft” value of barrier
arms rotation for more comfortable passage.
13. Install the housing (1) on the turnstile base:
Insert the lower part of the housing hooks into the base grooves (6) and lower it half the
height.
Connect the indication cable (8) to the turnstile LED-indication and to the
X8 (INDICATION)
connector on the interface board and put the housing all the way down. When lowering the
housing, make sure that the indication cable (8) folds forward and is not pinched by structural
elements. Correct housing installation does not require great physical effort.
Secure the housing with four screws (7) on the bottom of the base.
23
Содержание TTR-10A Series
Страница 26: ...TTR 10A electromechanical tripod turnstile Figure 17 Connection layout 25 ...
Страница 34: ...www perco com ...
